Pair your CommBank Essential Plus with SugarianPOS
SugarianPOS sends the amount straight to your CommBank Essential Plus terminal through Linkly Cloud, so staff never key it in twice. Pairing takes about five minutes and is done once per terminal.
Before you start
Pair the terminal
-
Connect the terminal to Linkly Cloud (first time only)
On the terminal press FUNC, enter 7410 and press Enter. Choose 2. Terminal Set Up, then Begin, then Cloud Comms.
For Wi-Fi, choose Setup Wi-Fi and join your network. For Ethernet, plug the cable into the terminal.
The terminal tests the connection and then shows that the Cloud terminal setup is complete. Press OK.
-
Show the pair code
If the terminal now asks about the PIN Pad Pairing Code, press Enter. Otherwise (and whenever you pair again later) press FUNC, enter 8880 and press Enter.
The 6-digit code works for 180 seconds. If it runs out, press Enter on the terminal for a new one. -
Enter the details in SugarianPOS Admin
Log in to SugarianPOS Admin and open Card terminals. Under Pair a terminal, choose the store, give the terminal a name staff will recognise, enter the Linkly Cloud username and password, type the pair code from the terminal, leave Live (from CommBank) selected, and press Pair.
When it works you see Paired "Counter" with Master Ngan Haymarket. The password is used once to pair and is not stored. -
Choose the terminal on each POS tablet
On each POS tablet that uses this terminal, open Settings → Card terminal and tap Counter. If the store has only one terminal, the tablets choose it by themselves.
-
Try a small sale and a refund
Ring up something small, for example a drink, and press Card. The amount appears on the terminal; tap or insert a card. The POS shows Payment approved and prints the receipt.
To refund it, open Orders, find the order, press Refund, choose Card and confirm. The terminal asks for the card.
If something goes wrong
| What you see | What to do |
|---|---|
| "Linkly did not accept that username, password or pair code" | Check the username and password in the Linkly email. Show a new pair code (FUNC 8880 Enter) and pair again within 180 seconds. |
| "Cloud Connect Failure" on the terminal | Check the terminal's Wi-Fi or cable. FUNC 7410 → 1. Cloud Diagnostics shows the connection. Then run step 1 again. |
| "Needs pairing again" in Card terminals | The Linkly Cloud password was changed, or the terminal was paired with another POS. Press Pair again in the admin and do steps 2 and 3. |
| The terminal does not respond, or the internet is down | On the pay screen press Terminal not working? Use it standalone, key the amount on the terminal, and press Approved when the terminal approves it. |
| The POS closed or lost power during a payment | Open it again. It checks the payment with Linkly by itself and prints a Card payment check slip. Only charge again if the slip says nothing was charged. |
| "No answer from the terminal yet" / result unknown | Do not charge again. Check the terminal's screen, then press Check again. |
| Lost the Linkly Cloud login, or need it reset | Contact Linkly Support: 02 9998 9800 or support@linkly.com.au. |
| Replacing or moving a terminal | In Card terminals press Remove for the old one, then pair the new one. |
Good to know
Each terminal is paired with one store. Several POS tablets in that store can use the same terminal.
SugarianPOS never sees or stores card numbers. Receipts come from the terminal and print on the POS receipt printer.
No card surcharge is added by SugarianPOS.
The terminal steps follow Linkly's Linkly Cloud Set up Guide. Menu names can differ slightly between terminal software versions.